Purchased equipment: gas turbine waste heat boiler steam performance
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

gas turbine waste heat boiler steam performance
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

WASTE HEAT RECOVERY (HRSG) Performance - Scri

If the waste heat in the exhaust gases is insufficient for generating the required amount of process steam, auxiliary burners which burn fuel in the waste heat boiler or an after-burner in the exhaust gases flue are added. Waste heat boilers are built in capacities from 25 m3 almost 30,000 m3 / min. of exhaust gas.

Energy Tips – Process Heati

Energy Tips – Process Heating The energy efficiency can often be increased by using waste heat gas recovery systems to capture and use some of the energy in the flue gas. However, the waste boiler generates steam only when the fuel-fired process is operating.

Waste Heat Recovery | Gas Turbine | Ste

If no alternative waste heat recovery Hot well Fig. involving an about 16% reduction of the total steam production. it is further recommended to install a bypass that allows exhaust gas to be bypassed the exhaust boiler Fig. gas boiler sections: A. HP-preheater D.When using the dual-pressure steam Alternative WHR sources for feedwater

Study the Performance of the Combined Gas Turbine-Steam Cycle for Power Generati

optimum gas turbine and steam turbine conditions for the combined cycle. The reheat gas turbine-steam turbine combined cycle is better as compared to the simple gas turbine-steam turbine combined cycle, because the output per unit mass of air flow is significantly improved by 35-41%, and the efficiency is higher by 4 % for the combined cycle

Waste Heat Recovery System (WHRS) - marine.mandieselturbo.c

by utilising this exhaust gas energy in a waste heat recovery system compris-ing both steam and power turbines, and combined with utilising scavenge air energy for exhaust boiler feed-water heating. This paper describes the technology behind waste heat recovery and the potential for ship-owners to lower fuel costs, cut emissions, and the effect on

Waste Heat Recovery Systems (WHRS) - MHI-M

The exhaust gas partially extracts from the main engine exhaust gas, then it drives the exhaust gas power turbine, which is connected to the steam turbine, with an SSS Clutch. The power generation amount is 2.4 to 2.8 times more than the Eco-TG System (without gas bypass).

Steam turbine - ThermoGen Power Services In

› Gas Turbine Heat Rate › Gas Turbine Power Output › Power Plant Boiler Efficiency › Steam Turbine Efficiency › Condenser Performance › Cooling Tower Efficiency. READ MORE. TGPS has evaluated the power plant performance of over 25,000 MW. Canada. Innocenter Builiding 550 Rue Sherbrooke W. Suite 200 Montreal, QB, H3A1B9. Mexico.

Waste Heat Recovery System (WHR

Waste Heat Recovery System (WHRS) for Reduction of Fuel Consumption, Emissions and EEDI

Study the Performance of the Combined Gas Turbine-Stea

performance of the heat recovery steam generator (HRSG) and consecutively the steam turbine improves thereby, offering improvement in combined cycle performance (Yadav, J.P., Singh,Dr O.,2006) . The literature has often suggested combining two or more thermal cycles within a single power plant.

Effect of Gas Turbine Exhaust Temperature, Stac

used to produce steam generation in the waste heat boiler recovery steam generator for steam turbine with the object to i.e. turbine exhaust temperature, stack temperature and ambient temperature one to two variables are constant. Figure predicting the performance of gas turbine cycle” Int. J. Theoretical Applied Mechanics, Vol.5

Waste Heat Recovery Unit after gas turbines - Alfa Lav

optimized for recovering waste heat after gas turbines. Application The waste heat recovery unit recovers thermal energy in the waste heat from the gas turbine exhaust gas, enabling generation of hot water, saturated steam or superheated steam. The WHRU is also capable of heating up thermal oil and TEG, and can be designed to fit individual

text