Purchased equipment: vertically shaped boilers for power generating plant
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

vertically shaped boilers for power generating plant
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

modern - boiler - types - and - applications -

The efficiency of the power plant can be improved significantly by connecting a heat recovery boiler These boilers are usually natural circulation boilers. If the life span of

Steam Boilers | Boiler | Steam Engine - scribd.c

The boilers which produce steam at pressure below 80 bar are called low pressure boilers Examples: Cochran, Cornish, Lancashire and locomotive boilers Stationary and portable Stationary boilers are used for power plant-steam, for central station utility power plants, for plant process steam etc

CFB Technology for Retrofitting Aged Supercritical Powe

The power plant consists of 8 x 300 MWel coal-fired blocks built between 1964 and 1972. To each block corresponds one steam turbine and two boilers of slag tap firing type, burning anthracite.

Power Plant Electrical Distribution Systems - PDHonline.c

Power Plant Electrical Distribution Systems Gary W Castleberry, PE 2008 PDH Center operating the power plant is in the business of generating electrical power twenty four hours a day, seven days a week. to fire boilers as tall as a twenty five story building.

Water-tube boiler - Wikiped

Such watertube boilers in thermal power stations are also called steam generating units. The older fire-tube boiler design, in which the water surrounds the heat source and gases from combustion pass through tubes within the water space, is a much weaker structure and is rarely used for pressures above 2.4 MPa (350 psi).

Typical 500 MW Coal Fired Plant - stormeng.c

power and in effect, reduces the net thermal efficiency of the plants. Utility boilers built in the 1960’s and 1970’s were designed for zero generate peak power. If the plant is boiler feed pump limited, then reheat sprays are a way to increase output by increasing steam mass flow through the IP and LP turbines. This is an

Air Heaters: Neglect at Your Own Risk - Power Engineeri

Steam Generating Systems at Electric Utilities are Essentially a Series of Heat Exchangers: condensers, deaerators, feedwater heaters and, of course, boilers and superheaters.

What is the pressure inside a boiler? What is the effec

1900s Large industrial steam boiler like in thermal power plant typically use water tube boilers as it can produce large steam flow rate (500 kg/s) and pressure up to 16 MPa (160 bar). [Ref22] Furthermore, water tube boilers can be installed in modern furnace that is used in chemical industry like radiant furnace.

(PDF) Modern Boiler Types and Applications - ResearchGa

The efficiency of the power plant can be improved significantly by connecting a heat recovery boiler (HRSG) to it, whic h uses the heat in the flue gases to generate steam.

18 MW Biomass Power Plant for Sale at Phoenix Equipmen

Phoenix Equipment power generation plants for sale with general electric gas and steam turbines. 18 MW condensing steam turbine and power plant for sale. Gas fired steam turbine for sale. Power generation plants are available at Phoenix Equipment. Waste heat boilers and steam boilers included with biomass power plant for sale.

Spiral watertube boiler - Wikiped

The boiler was also successfully fired with bagasse, plant waste or refuse. Where they were used for continual high-power production, such as for electricity generation, some were also used with early automatic stokers. One advantage of these boilers was the rapidity with which they could be constructed.

text